Veripart VPSBS177Z Benutzerinformation Seite 66

PROBLEM
There is too
much frost and
ice.
The compressor
works
continuously.
The lamp does
not work.
Poor cooling
efficiency
POSSIBLE CAUSE
- The door is not closed properly.
- The door gasket is deformed or
dirty.
- The products are not packed
correctly.
- The temperature is set incorrectly.
- The appliance is fully loaded and
set to the lowest temperature.
- The set temperature in the
appliance is too low and the
ambient temperature is too high.
- The temperature is set incorrectly.
- Many products are placed at the
same time.
- The room temperature is too high.
- The food placed in the appliance
was too hot.
- The door is not closed properly.
- The lamp is broken.
- The lamp is in the standby
position.
- Do you put hot food or too
much food in the appliance?
- The door does not close
properly.
- Is there direct sunlight or a
stove or heater nearby?
- Is the appliance properly
ventilated?
The temperature set too high?
SOLUTIONS
- Find the cause of the door not
closing properly, remove or
move possible obstacles.
- As a result, the door does not
close properly. Clean the seal
and repair the deformation.
If necessary, replace the seal,
contact customer service.
- Pack the products better.
- Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Set a higher temperature.
Please refer to Section 4.
- Please refer to Section 4.
- Wait a few hours and then
check the temperature again.
- Please refer to Section 4.
- Allow food to cool to room
temperature before storing.
- See the previous section.
- Please contact our customer
service.
- Close and open the door.
-
-
-
-
-
66
Cool hot food before putting
it in the appliance.
Check the door and door
rubbers and see if the door
is blocked.
Place the appliance further
away from the heat source.
Ensure sufficient distance to
ensure proper ventilation.
Set the appropriate
temperature.