DeWalt DW008 Anweisungen Seite 22

E N G L I S H
Do not store or carry the battery pack
without the battery cap placed over the
contacts.
• The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact,
flush immediately with water. Neutralize with a
mild acid such as lemon juice or vinegar. In case
of eye contact, rinse abundantly with clean water
for at least 10 minutes. Consult a physician.
• Never attempt to open a battery pack for any
reason.
• Use only chargers labelled „NiMH" or „NiMH +
NiCd" to charge D
E
• Do not expose the charger to damp or wet
conditions.
• Do not attempt to charge wet battery packs.
Labels on charger and battery pack
In addition to the pictographs used in this manual,
the labels on the charger and the battery pack show
the following pictographs:
Battery charging
Battery charged
Problem charging
+
Charges NiMH and NiCd battery packs
Do not probe with conductive objects
Do not charge damaged battery packs
Read instruction manual before use
Do not expose to water
22
WALT NiMH battery packs.
Have defective cords replaced
immediately
Charge only between 4 °C and 40 °C
See technical data for charging time
Always wear safety glasses when
plugging in the charger
Additional safety rules for cutsaws
Switching on and off
• After switching off, never attempt to stop the saw
blade with your fingers.
• Never put the saw down on a table or work
bench unless switched off. The saw blade will
keep running briefly after the tool has been
switched off.
When sawing
• When using saw blades specially designed for
cutting wood remove all nails and metal objects
from the workpiece before starting work.
• Wherever possible, use clamps and vices to
fasten the workpiece securely.
• Do not attempt to saw extremely small workpieces.
• Do not bend too far forward. Make sure that you
always stand firmly, particularly on scaffolding
and ladders.
• Always hold the saw with both hands.
• For cutting curves and pockets, use an adapted
saw blade.
Checking and changing the saw blade
• Only use saw blades conforming to the
specifications contained in these operating
instructions.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent saw
blades should be discarded and replaced at once.