Maintenance; Optional Accessories; Protecting The Environment - DeWalt XR LI-ION DCS310 Originalanweisungen

Always be sure blade is completely through material
before continuing with pocket cut.
NOTE: In areas where blade visibility is limited, use
the edge of the saw shoe as a guide. Lines for any
given cut should be extended beyond edge of cut
to be made.
METAL CUTTING (FIG. 12)
Your saw has different metal cutting capacities
depending upon type of blade used and the metal
to be cut. Use a finer blade for ferrous metals and a
coarse blade for non-ferrous materials. In thin gauge
sheet metals it is best to clamp wood to both sides
of sheet. This will ensure a clean cut without excess
vibration or tearing of metal. Always remember not
to force cutting blade as this reduces blade life and
causes costly blade breakage.
NOTE: It is generally recommended that when
cutting metals you should spread a thin film of oil or
other lubricant along the line ahead of the saw cut
for easier operation and longer blade life.
HORIZONTAL/VERTICAL SAW MODES (FIG. 13)
The saw can be used in either of the modes shown.
Horizontal Mode: Blade teeth face downward as
shown in figure 13A.
Vertical Mode: Blade teeth face forward as shown
in figure 13B.
The DCS310 can accept all lengths of reciprocating
blades. For best results use 4" (102 mm) blades.
Ensure the blade extends past the shoe and the
thickness of the workpiece during the cut. Use a
longer blade if needed. Whenever possible, the
saw shoe must be held firmly against the material
being cut. This will prevent the saw from jumping or
vibrating and minimize blade breakage.

MAINTENANCE

Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: To reduce the risk
of serious personal injury, place
the lock-off button in the lock-
off position or turn tool off and
disconnect battery pack before
making any adjustments or
removing/installing attachments or
accessories. An accidental start-up
can cause injury
The charger and battery pack are not serviceable.
There are no serviceable parts inside.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
EN GL IS H
WALT, have
E
39