Changing The Batteries; Troubleshooting - Sinocare Safe AQ UG Benutzerhandbuch

frequency interference at the frequency range and test levels specified by IEC 61326-2-6:
2012.
● Do not use this instrument in close proximity to sources of strong electromagnetic
radiation, as these may interfere with the proper operation.
● Avoid dirt, dust, blood, control solution or liquids into the meter test port.
● Do not keep meter in an area where it may be crushed.
● Store blood glucose monitoring system (meter, test strip, control solution) in a dry
place.
● Do not freeze.
● Do not store in the kitchen or bathroom.

Changing the batteries

Make sure your meter is off when you change the batteries.
Caution:
Keep batteries away from children. If the battery is swallowed call healthcare
professional immediately.
Step 1:
Slide the battery cover out of the meter.
Step 2:
Remove the old batteries. Place the new ones in the drawer according to the inner
compartment directs of "+" and "–" side.
Step 3:
Slide the battery cover back into position until it locks into place.
41

Troubleshooting

Display What it means
Your blood glucose test
result is below the
measurement limit, which
is less than 20 mg/dL or less
than 1.1mmol/L.
Your blood glucose test
result is higher than
600 mg/dL or 33.3mmol/L.
Your uric acid test result is
lower than 3.0mg/dL or
181μmol/L.
What to do
Use a new test strip to test again, if
meter still display "LO", call
healthcare professional immediately.
Use a new test strip to test again, if
meter still display "HI", call
healthcare professional immediately.
Use a new test strip to test again, if
meter still display "LO", call
healthcare professional immediately.
42