Comparing Meter With Laboratory Results; Cleaning And Disinfecting - Sinocare Safe AQ UG Benutzerhandbuch

6. Wash hands thoroughly with soap and water after handling the meter, lancing device or
test strips.
7. Cleaning and disinfecting meter and lancing device before use on next patient.

Comparing Meter with Laboratory Results

When comparing results between Safe AQ UG blood glucose and uric acid monitoring system
and a laboratory system, Safe AQ UG blood glucose and uric acid monitoring system blood
tests should be performed within 30 minutes of a laboratory test.
35

Cleaning and Disinfecting

Clean and disinfect meter immediately after getting any blood on the meter or if meter is
dirty.
If the meter is being used on second person, the meter and lancing device should be clean
and disinfected first. Do not clean the meter during the test.
To clean the meter:
1. Wash hands thoroughly with soap and water.
2. Make sure meter is off and a test strip is not inserted. Use 75% alcohol to rub the entire
outside of the meter. Make sure no liquids enter the test strip port or other opening in the
meter.
3. Let meter air dry thoroughly before using to test.
4. Wash hands thoroughly again after handing meter.
5. Verify the meter is working properly by performing control solution test. If your meter
can't work properly, please contact customer service at +86-731-89935581/
+86-731-89935582 or contact local dealers.
To disinfect the meter:
Please according to clinic institution disinfect method to disinfect the meter.
36