Herunterladen Inhalt Inhalt Diese Seite drucken

IBO MAGI 2 25-40/180 Betriebsanleitung Seite 13

Energiesparende umwälzpumpe
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING: Failure to observe instructions
!
marked in this way will most probably cause
bodily injury!
WARNING!!!
Before proceeding to install the device, carefully read
the instructions for installation and operation of the
!
device. The installation and use of the device must
conform to the local regulations and this manual.
Precautions on use of MAGI 2 series pumps
1.Before installation, read the following manual carefully
2.Failure to observe the fragments marked with warning signs may cause bodily injury, pump damage and other property losses,
for which the producer takes no lability, including but not limited to liability for damages.
3.The fitter, maintenance technician and user have to observe the local safety regulations.
4.The user must confirm that the installation and maintenance of the product are performed by personnel having adequate
knowledge and professional experience connected with the structure and operation of heating systems.
5.Pumps cannot be installed in moist environment or in places which can be exposed to flooding with splattering water.
6.To make maintenance easier, place a ball valve on both sides of the pump.
7.During installation and maintenance, cut off the electric power supply from the pump.
8.The central heating circuit cannot be frequently refilled with non-softened water to avoid accumulation of scale in the
pipeline. High accumulation of scale can block the rotor of the device.
9.The pump cannot be run without a heating medium.
10.If the pump is dismounted from the pipeline, either discharge the heating medium from the system or close the ball valves
cutting the pump off before dismounting to avoid possible burning with the heating medium. Please remember that the
heating medium can have high temperature and pressure.
11.In dismounting the pump from the pipeline, the heating medium, which can have high temperature and high pressure, will
flow outside. Please be careful not to cause bodily injury due to burning and not to flood other devices.
12.In summer or when the ambient temperature is high, pay attention to proper ventilation in the room where the pump has
been installed. It will help prevent condensation of humidity, which can cause an electric failure.
13.In winter, if the central heating system where the pump has been installed does not work and the ambient temperature is
below 0 ° C, discharge water from the heating system. Please bear in mind that freezing water can burst the pump body.
14.If the pump does not operate for a long time, close the ball valves cutting off the pump and cut off electric power supply.
15.If the electric wire powering the pump is damaged, refer to an authorised servicing team to replace it along with its switch.
16.If the pump motor heats up excessively (more than usually), immediately disconnect the pump from its power source, close
the cut off valves and contact a servicing team.
17.If a pump failure cannot be removed according to the manual, immediately disconnect the pump from its power supply, close
the cut off valves and immediately contact the local manufacturer or the servicing centre.
18.The product must be placed in a place far away from children and measures to isolate the product must be taken to avoid
children touching it.
19.The product must be connected to the electric mains equipped with efficient electric earthing. The yellow-green core of the
connection cable is earthing.
20.The product must be connected to mains equipped with a residual current circuit breaker with tripping current In not
exceeding 30 mA.
21.The product must be placed in a dry, well-ventilated and cool place and stored at room temperature.
22.This equipment is not intended for use by persons (including children) with reduced motor, sensory or mental capacities, or
persons without experience or not familiarised with the equipment, unless it is performed under supervision or according to
the instruction regarding operation provided by persons responsible for their safety. Attention should be paid so that children
do not play with the equipment.
USE AND CARE GUIDE MAGI 2
Failure to observe instructions marked in this way
can cause equipment damage!
Failure to observe instructions marked in this way
can cause equipment damage!
WARNING!!!
People (including children) with limited physical, sensory
or mental capacity or people without experience or
!
knowledge in equipment must use the pump under
supervision and guidance of the people who can take
responsibility for their safety.
13

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Magi 2 25-60/130Magi 2 25-60/180

Inhaltsverzeichnis