HOMCOM 800-116V70 Bedienungsanleitung Seite 5

OPERATING PROCEDURES & MAINTENANCE
Touch Control Panel:
A. Button to select milkshake function
B. Button to select soft ice-cream function
C. Button to select hard ice-cream function
D. Button to increase the ice cream making time
E. Button to decrease the ice cream making time
F. Button to select stir function
G. Button to turn on/off the unit.
H. LED display window
I. LED Light for work state and system warning indicator
UNPACKING YOUR ICE-CREAM MAKER
1. Remove the exterior and interior packaging. Check if all the parts, such as
the paddle,ice-cream mixing bowl, and ice-cream scoop etc., are inside. If any
parts are missing,please contact our customer service.
2. Clean the ice-cream mixing bowl, paddle, and ice-cream scoop first.
3. Put the unit on a level & flat counter top, and without direct sunlight and
other sources of heat (i.e.: stove, furnace, radiator).
4. Make sure that there is at least 10mm gap between the back & LH/RH sides
with the wall.
5. Allow one hour for the refrigerant fluid to settle before plugging in the unit.
6. The appliance must be positioned so that the plug is accessible.
CONNECTING YOUR ICE-CREAM MAKER
*Improper use of the grounded plug can result in the risk of electrical shock.
If the power cord is damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this
appliance is equipped with a grounding plug which mates with standard grounding
wall outlets to minimize the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounding wall outlet.
Do not under any circumstances; damage the grounding means of the plug under
any circumstances. Any questions concerning power and/or grounding should be
directed toward a certified electrician.
3. This appliance requires a standard 220 Volt, 50 Hz electrical outlet with good
grounding means.
4. DO NOT immerse the compressor/motor base in water.
CLEANING AND MAINTAINING YOUR ICE-CREAM MAKER
Before using your ice-cream maker, it is strongly recommended to clean it
thoroughly.
1. Turn the transparent cover by counterclockwise, be sure the arrow on lid is lined
up with the lock icon on the base, and then you can take the cover out.
2. Take out the paddle and ice-cream mixing bowl.
3. Use a dry, clean, soft cloth to clean the internal wall of the ice-cream making
housesmoothly, no need to use water or wet cloth to clean it.
4. The outside of the unit should be cleaned regularly with a mild detergent solution
and warm water. DO NOT immerse the compressor/motor base in water. It will wet
EN
!
4