Husqvarna BMC 335 Bedienungsanweisung Seite 17

• Monitor the ammeter during the operation. The
maximum amperage for each motor type is as
follows:
a) For motor type 3x400V, 50 Hz: 27.4 A.
b) For motor type 3x480V, 60 Hz: 23.4 A.
• To make it easier to move straight, fold down the
direction pointer.
The direction pointer can be adjusted laterally.
To do a pairing operation BMC 335RC
The first time the remote control is used together with
the product or if the remote control is replaced, a pairing
operation is necessary.
1. Make sure that the emergency stop button is
disengaged. Refer to
emergency stop button on page 10 .
2. Connect the power cord. Refer to
product to a power source on page 14 .
1816 - 001 - 05.04.2022
To do a check of the
To connect the
3. Set the remote control switch (A) to "REM".
A
4. Push the ON/OFF button (B).
B
D
5. Push the button for pairing operation (C). When
the display shows "RX ON" the remote control is
connected to the product.
To operate the product with the remote
control
Note:
The remote control has a built-in operator
presence control. The remote control must be level to
operate the product. If the remote control is not level, the
product stops.
C
17