Husqvarna BMP 335 Bedienungsanweisung Seite 11

To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Connect the dust extractor hose to the connection
for dust extractor. Refer to
2 for information about where the connection for dust
extractor is on your product.
1838 - 002 - 06.04.2022
A
B
C
Do not use the dust
Product overview on page
To connect the product to a power
source
1. Connect the power plug of the product to an
applicable extension cable.
2. Connect the extension cable to a mains outlet.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
To start the product
1. Start the dust extractor.
2. Put the cord of the operator presence control around
your right wrist.
3. Push the drive system pedals to engage the drive
system.
When the product is
11