6. Install the side cover.
7. Install the support plate.
8. Do a check of the drive belt tension. Refer to
check of the drive belt tension on page 17 .
10
To adjust the height of the front wheels
The standard position is (B). Position (A) is used for
operation at maximum depth. Position (C) is used for
operation at minimum depth.
1. Loosen the bolts (D) on each side of the front wheel
bar.
To do a
D
2. Turn the nut (E) to set the applicable height.
3. Tighten the bolts (D) on each side of the front wheel
bar.
A
B
C
D
E
1838 - 002 - 06.04.2022