Functional Description - Makita SD100D Betriebsanleitung

Please also
more detailed
Tape or mask
contacts and
the battery in such a manner that it
cannot move around in the packaging.
11. Follow your local regulations relating to
disposal of battery.
SAVE THESE INSTRUCTIONS.
CAUTION:
Only use genuine Makita batteries.
Use of non-genuine Makita batteries, or batteries that
have been altered, may result in the battery bursting
causing fires,
damage.
void the Makita warranty for the Makita tool and
charger.
Tips for maintaining maximum
battery life
1. Charge the battery cartridge before completely
discharged. Always stop tool operation and
charge the battery cartridge when you notice
less tool power.
2. Never recharge a fully charged battery
cartridge. Overcharging shortens the battery
service life.
3. Charge the battery cartridge with room
temperature at 10 °C - 40 °C (50 °F - 104 °F).
Let a hot battery cartridge cool down before
charging it.
FUNCTIONAL
DESCRIPTION
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking function on the tool.
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery
cartridge firmly when installing or removing
battery cartridge. Failure to hold the tool and the
battery cartridge
them
your
damage to the tool and battery cartridge and a
personal
►
Fig.1: 1. Red indicator 2. Button 3. Battery
cartridge
To remove the
cartridge, slide it
tool while sliding the button on the front of the
cartridge.
observe possibly
national regulations.
off open
pack up
personal injury and
It will also
firmly may cause
to slip off
hands and result in
injury.
battery
from the
To install
cartridge, align
the battery cartridge with the groove in the
housing and slip it
it all
it locks
a little
can see
on the
locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If
not,
accidentally
of
causing
someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If
not
it
correctly.
Battery protection system
The tool
a battery
system automatically
power to
extend battery life.
The tool
stop during
tool and/or
under one
conditions:
Overloaded:
The tool
a manner
to draw
In this
tool off
application that
to become
turn the tool on to restart.
If the
start, the
overheated.
battery cool before turning the tool on again.
Low battery voltage:
The remaining battery
too low
will not
turn the
motor runs
soon. In
and recharge the battery.
9 ENGLISH
the battery
the tongue on
into place. Insert
the way until
in place with
click. If you
the red indicator
upper side of the button, it is not
it may
fall
the tool,
injury to
the cartridge
slide in
is not being inserted
is equipped with
protection system. This
cuts off
the motor to
will automatically
operation if the
battery are placed
of the following
is operated in
that causes it
an abnormally high current.
situation, turn the
and stop the
caused the tool
overloaded. Then
tool does not
battery is
In this situation, let the
capacity is
and the tool
operate. If you
tool on, the
again but stops
this situation, remove
out
you or
does
easily,