Makita SD100D Betriebsanleitung Seite 10

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.2: 1. Indicator
Check button
Press the check
the battery cartridge
the remaining battery
indicator lamps light up for few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
►
Fig.3: 1. Switch trigger
CAUTION:
Before installing the battery
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the
pull the switch
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
To prevent the
from being pulled
the trigger-lock button
To start the
trigger-lock button from the
the switch trigger.
always press in
lamps 2.
button on
to indicate
capacity. The
Remaining
capacity
Of
f
75% to 100%
50% to 75%
25% to 50%
0% to 25%
tool, simply
trigger. Tool
switch trigger
accidentally,
is provided.
tool, depress the
side and pull
After use,
the trigger-
lock button from the
lock button
CAUTION:
When not operating the tool,
depress the trigger-lock button from the
lock the switch trigger in the OFF position.
Adjusting depth of cut
The cutting
with the
blade. Loosen the screw on the blade holder until the
blade can
the scale
with the
the blade
the screws.
►
Fig.5:
blade holder 3. Scale on the blade
The maximum cutting
on the
saw blade.
saw blade
the working material.
Type of saw blade
For drywall
For wood
LED light
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the
light up
lamp keeps on lighting while the switch trigger is
being pulled. The
approximately
releasing the trigger. ►
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Removing the dust collector
CAUTION:
Never operate the tool without the
dust collector. Dust may come into your eyes and
cause eye
To remove
hold the
10 ENGLISH
side. ►
Fig.4:
depth corresponds
scale on
move freely.
on the
bottom line
holder. Then
1. Cutting depth 2. Bottom line of the
depth
type of
Always use
designed for
Max. cutting depth
30 mm
15 mm
switch trigger
the lamp.
lamp goes
10 seconds
Fig.6:
injury.
the dust
tool handle
1. Trigger-
side to
the
Align
blade
of
tighten
depends
the
the
cutting
to
The
out
after
1. Lamp
collector,
and