Elica NIKOLATESLA ONE Montage- Und Gebrauchsanweisungen Seite 65

Note: on the side of the display of the cooking zone, the
following symbol will appear
To switch off the Timer:
• select the cooking zone
• set the value of the timer to " " , by means of
Not: the function remains active if no other key is pressed
in the meantime.
Egg Timer
The Egg Timer function is a countdown independent of the
cooking zones (and the extraction zone). The Egg Timer is
activated by pressing
Note : to regulate the Egg Timer function, follow the same
procedure as for the Timer function.
When the timer has finished the countdown, there is an
acoustic signal (for 2 minutes, or it will stop when one of the
buttons on the hob is pressed), while the display (15) will
flash, with the symbol " .
Pause
The Pause function allows to suspend any function active on
the hob, bringing the cooking power to zero.
Activation:
• press (10)
• a " " is displayed (13).
To deactivate the function:
Note :this operation restores the hob settings to those prior
to the pause.
• press (10)
• within 10 seconds scroll to the right along
the Selection bar (3), relating to the cooking zone 2
(FIG.19);
Note : if the operation is not performed within this time
the pause function will remain active.
Note: if after 10 minutes, the Pause Function is not
deactivated, the hob will turn off automatically.
Recall
The Recall function allows to recover all the hob settings, in
case of accidental shut-down.
(19)
(8) .
".
Activation:
• turn the hob back on
within 6 seconds after shut-down
• press " "
within the next 6 seconds
Automatic Heat UP
The Automatic Heat UP function allows to reach the set power
faster; with this function it is possible to cook food faster, but
without the risk of burning it, because the temperature does
not exceed the set level.
This function is available for the levels of power 1 -8 .
Activation:
• press and hold, on the Selection bar (3), the desired
power
• a " " is displayed (13).
Power Limitation
The Power Limitation function allows the product to be used
while limiting its maximum absorption.
Note : the limit must be set when the hob is off, without
, within 2 minutes from when the hob is
pressing
connected to the electrical network, or from when the
electrical network itself is reconnected.
To set the Power Limitation:
- press and hold keys
sounds
- slide along sliders FL and RL
same time, from left to right,
and press down at the letters P, until a short acoustic signal
sounds
2. the Timer display (15) shows the symbols
to indicate that it can be set
3. the FL zone display shows the current setting**
0 = 7.4 KW
1 = 4.5 KW
** by default, the limit is set to 7.4 KW
- to change the Power Limitation setting slide on the FL
slider
- from left to right to increase the Kw
- from right to left to decrease the Kw
- to save the selection, press the keys
second;
63
, until an acoustic signal
at the
" "
CF6
, for 1
,