How To Use; Maintenance; How To Clean - Panasonic ER-CSF1 Betriebsanleitung

How to use

• Clean the appliance after use.
1
Mount the head to the main body until it clicks.
2
Turn on the power.
Note
• The use time after a full charge is as follows.
ER‑CBL1: 50 minutes
ER‑CBN1: 40 minutes
(Based on dry using at 20 °C – 30 °C)
The operating time may differ depending on the frequency of
use and the operating method.
Quick charge (ER‑CBL1 only)
Even though the battery runs out, you can use for 5 minutes
after 3‑minute charge.
(This will differ depending on usage.)
Removing and mounting
the head (Fig. 2)
• Make sure that the main body is turned off.
Remove the head while pushing the head release button (a).
▪ Stand the head when it is removed.
Mount the head to the main body until it clicks.
Shaving (Fig. 3)
Apply the whole system outer foil perpendicularly against the
skin and shave by slowly gliding the appliance over the face
against the grain of the beard.
• The beard under the chin and around the throat can be
shaved better by stretching the skin to raise the beard.
• To prevent damaging the system outer foil, do not shave with
only a part of the system outer foil.

Maintenance

• Make sure that the main body is turned off.
• Lubricate after cleaning and store the head with the
protective cap attached.

How to clean

► W ith water
1
Apply some hand soap and some water to the system
outer foil. (Fig. 4‑1)
2
Turn on the power and turn off the power after 20 seconds.
3
Remove the head and the outer foil section.
4
Rinse them with running water. (Fig. 4‑2)
5
Shake up and down several times to remove the water.
▪ Be careful not to hit the appliance on the sink or any other
object while draining the water.
6
Wipe off the water with a dry cloth and dry it well.
▪ Allow the head to dry in the shade, avoid direct sunlight.
▪ Do not dry the appliance with a dryer or a fan heater.
Notes
• Do not wipe with thinner, benzine, alcohol etc. Doing so may
cause malfunction, cracking or discoloring of the parts.
► W ith the cleaning brush
1. Remove the outer foil section and the inner blades.
2. Brush off any hair trimmings from the head and the outer
foil section. (Fig. 5)
▪ Clean the inner blades using the brush by moving it in
direction as illustrated.
▪ Do not move the brush perpendicularly against the blades
as it will damage the inner blades and affect their sharpness.
7