Kayoba 006373 Bedienungsanleitung Seite 22

2 Safety
2.1 Safety definitions
Warning! If you do not obey these instructions, there
is a risk of death or injury.
Caution! If you do not obey these instructions, there
is a risk of damage to the product, other materials or the
adjacent area.
Note! Information that is necessary in a given situation.
2.2 Safety instructions for operation
Warning! If you do not obey these instructions, there
is a risk of death or injury.
● The instructions describe how to ride safely and keep the
product in good condition. Read the instructions carefully,
and follow them. All the important servicing and
adjustments of the product should be carried out at a
bike shop. Follow these instructions if you do not have
access to a bike shop or want to do the adjustments
yourself.
● Follow local traffic regulations.
● Always wear a bike helmet.
● If dark, use the lamps on the product. Wear bright
clothes, if possible.
● If wet, the power of the brake is reduced. Cycle more
slowly and apply the brake earlier than in dry weather.
3 Assembly
3.1 Suitable tools for assembly and
adjustment
● Combination spanners, size 13 and 15 mm.
● Hex keys, size 5 and 6 mm.
● Screwdrivers.
● Grease.
3.2 To assemble the handlebars
1
Make sure that the brake wire and gear wire are put
on the right side of the front fork. If the wires are not
correct installed. Rotate the wires to the correct
position.
22
2
Apply grease to the hole on the front fork and the
expander bolt at the foot of the handlebars.
3
Install the handlebars at the required height in the
hole on the front fork. Make sure that it is deep
enough to be stable.
4
Make sure that the handlebars are straight and
tighten the clamping screw with a 6 mm hex key.
3.3 To assemble the front wheel
1
Push the front brake together and unhook the brake
wire so that the brake separates.
2
Hook the front wheel in the front fork, with the tyre in
the correct direction of rotation.
3
Make sure that the front wheel is centred between
the fork legs. Tighten the nuts alternately.
4
Push the front brake together and install the brake
wire. (Figure 2)
3.4 To install the saddle and the
saddle post
1
Put grease on the saddle post.
2
Install the saddle post into the saddle tube.
Note! Make sure that the marking for the top position on the
saddle is below the edge of the saddle tube.
3
Lock the saddle post to the required height with the
quick-release lever.
3.5 To assemble the pedals
Note! The right pedal is marked with a R, and the left pedal
is mark with a L. Install the right pedal on the right side of
the bike, and the left pedal to the left side of the bike. If the
pedals are not installed correctly, it can cause damage to
the threads on the pedals.
3.5.1 To fit the right pedal
1
Turn the pedal clockwise on the chain side of the
crank arm.
2
Tighten with a 15 mm combination spanner.
(Figure 3)
2022_001