Lubrication; Greasing The Front Wheel Bearings; Electrical System Maintenance; Maintaining The Batteries - Toro eS3000SD Bedienungsanleitung

Lubrication

Greasing the Front Wheel
Bearings
Service Interval: Every 25 hours
Grease type: General-purpose grease
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the machine and remove the key.
3. Clean the grease fittings with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
Figure 24
Electrical System
Maintenance

Maintaining the Batteries

Note:
The original batteries are maintenance-free
and do not require service.
WARNING
Battery terminals or metal tools could short
against metal components causing sparks.
Sparks can cause the battery gases to
explode, resulting in personal injury.
• When removing or installing the battery,
do not allow the battery terminals to touch
any metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
• Use insulated tools when maintaining the
batteries.
• Always keep the battery retainers in place
to protect and secure the batteries.
DANGER
Do not touch any electrical components or
contacts on the motor.
Touching any of these components or
contacts could seriously injure you or cause
g343313
death.

Cleaning the Batteries

Service Interval: Every 25 hours
1. Ensure that all the battery caps are tight.
2. Use a paper towel to clean the batteries.
3. If the battery terminals are corroded, clean them
with a solution of 4 parts water and 1 part baking
soda. Also, clean the posts and cable clamps
with a post and clamp cleaner.
Note:
The posts and clamps should have a
bright, metallic shine.
4. Apply a light coating of Toro battery-terminal
protector.
25