Emerio DH-127489.1 Bedienungsanleitung Seite 11

INTELLIGENT DEFROSTING
When the temperature is too low, frost may form inside the machine. The machine will automatically start
defrosting with the indicator light of mode button flashing. The compressor will work intermittently, and
automatically exit the defrost mode after finishing defrosting.
DRAINAGE
Emptying the water tank

When the tank is full, the unit will turn off and make a buzzing sound. The water full indicator light will turn
on and the digital display will show "FL".

Pull out the water tank. Empty the water in it.

Clean the inside of the water tank as well as the outside.

Replace the empty water tank back into the unit.

If the water full indicator light does not extinguish, check that the float is correctly in place.
Plastic rivet
Float
Warning
1. Do not discard the float or the plastic rivet. Otherwise, the machine will not automatically stop working when
the water tank is full, and the condensed water will overflow and damage the floor of the room.
2. Please be sure to clean the condensed water in the water tank before resetting the working mode of the
machine.
3. If the water tank is dirty, rinse it with clean water. Avoid using detergents, steel balls, chemical dust removers,
diesel oil, benzene, diluents or other solvents. Otherwise, the water tank will be damaged and leaked.
4. Replace the empty water tank back into the unit. Otherwise, the water full indicator light may remain red
and the machine cannot restart.
Check the float.
- 10 -
Remove the handle
from the water tank.
Remove the cover.