Husqvarna CR 125 Werkstatt-Handbuch Seite 101

D3-125-2005 16-06-2004 9:30
Lubricating the chain without OR
First dry, then plunge the chain in a bisulphide molybdenum lubricant, or in high
viscosity engine oil. Warm up the oil before use.
Lubricating the chain with OR
Lubricate all metallic and rubber (OR) elements using a brush, and use engine oil
with SAE 80-90 viscosity for the internal and external parts.
5 - If the chain has been cut, reassemble using a joint.
6 -Assemble the joint spring by turning the closed side to the chain direction of rota-
tion as shown in figure.
NOTE * : Even if all the joints are reusable when in good conditions, for safety pur-
poses we advise using new joints when reassembling the chain.
7 -Accurately adjust the chain as described on page D.40.
WARNING*: The chain oil has NEVER to get in contact with the tires or the rear
brake disk.
Chain tension rollers, chain driving roller, chain guide, chain runner
Check the wear of the above mentioned elements and replace them when necessary.
WARNING*: Check the chain guide alignement, and remember that a bent ele-
ment can cause a rapid wear of the chain. In this case, a chain fleeting from the
sprocket may ensue.
CHECKING THE WEAR OF CHAIN, PINION AND SPROCKET
Proceed as follows:
- Fully stretch the chain with the adjusting screws.
- Mark 20 chain links.
- Measure the distance between 1st pin center and 21st pin center.
Check the pinion damages or wear and replace it should the wear degree be as the one
shown in figure.
Remove the wheel and check the wear of the rear sproket teeth. The figure shows the
outline of teeth in normal and excessive wear. Should the sprocket be badly worn out,
replace it by loosening the six fastening screws to the hub.
WARNING*: Misalignment of the wheel will result in abnormal wear and may
result in an unsafe riding condition.
Note*: In muddy and wet conditions, mud sticks to the chain and sprockets resul-
ting in an overtight chain. The pinion, the chain, and the rear sprocket wheel
wear increases when running on muddy ground.
N° 8000A4439 (06-04)
Pagina D.41
REGISTRAZIONI E REGOLAZIONI
SETTINGS AND ADJUSTMENTS
REGLAGES ET CALAGES
EINSTELLUNG UND EINREGULIERUNGEN
AJUSTES Y REGULACIONES
WEAR
STANDARD
LIMIT
317,5 mm 323 mm
1- Chain tension roller
2- Chain driving roller
3- Chain guide
4- Chain slider
3
1
2
Consumo normale
Normal consumption
Consommation normale
Normaler verbrauch
Consumo normal
D.41