Mounting The Bicycles - uebler 19710 Montage- Und Bedienungsanleitung

Attention
When you are closing the quick release clamp (21), there is
a crushing hazard. Make sure that your hands are not pinched
when you are closing the quick release clamp (21).
8. Close the quick release clamp (21) again completely so that
the rack frame (12) is fixed.
Note
If the rack frame (12) is too loose, open the quick release
clamp (21) on both sides by about 90° upwards, press the
screws (23) outwards, screw them in by an additional quarter
turn, and completely close the quick release clamp (21).
If the quick release clamp (21) cannot be closed or is very
difficult to close, open the quick release clamp (21) on both
sides by about 90° upwards, press the screws (23) outwards,
screw them out by a quarter turn, and completely close the
quick release clamp (21). If the quick release clamp (21) is still
impossible or very difficult to close, repeat the procedure.
15
16
14 13
9. Screw in the buckles (15) with screws (13), washers (14) and
nuts (16) tight enough that the buckles (15) can still be rotated.
10. Adhere the paint protection film (18) to the luggage
compartment lid (29).
The dimension (A) should be approx. 200 mm.
11. Hang the hooks (30) on the luggage compartment led (29)
and pull the tensioning straps (19) taut with the buckles (15).
Attention
The hooks (30) should not be hung on plastic parts (such as the
rear spoiler) or glass panes.
All manuals and user guides at all-guides.com
12
A
15
A
19
21
M+P-25A-0149

Mounting the bicycles

Attention
The bicycle rack for the trailer hitch is only intended for
transporting bicycles.
Only bicycles, each with a max. weight of 30 kg, may be
transported on the bicycle rack.
The maximum allowable load capacity of the bicycle rack,
the tow bar load of the trailer hitch, the allowable total
vehicle weight and the maximum allowable vehicle axle
load (see vehicle owner's manual) must not be exceeded.
If these instructions are not followed, the bicycle rack together
with the mounted bicycles may free themselves from the
vehicle and cause injury to you and other persons, and/or may
result in an accident.
Attention
The bicycles must be mounted evenly and with a low centre
of gravity on the bicycle rack. Each must be secured against
falling off using a bracket on the bicycle frame and lashing
straps on front and rear wheels.
If this is not adhered to, bicycles and/or the loose parts could
free themselves from the vehicle and lead to an accident and
18
associated injury and property damage other road users.
Before mounting, remove child seats and all loose parts,
29
such a s water bottles, saddlebags, batteries from E bikes etc.,
from the bicycles and stow them.
30
Attention
A risk of injury exists if bicycles slip or tilt. Secure the bicycles
against slipping off/tilting.
Mount and dismount the bicycles together with another person.
- 11 -