Operation Tips; Maintenance; General Maintenance; Replace The Blade - Echo DLM-310/46SP Bedienungshandbuch

EN
8.6

OPERATION TIPS

• Do not try to override the operation of the start button or
bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9

MAINTENANCE

Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
9.1

GENERAL MAINTENANCE

• Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use water.
9.2

REPLACE THE BLADE

Figure 10.
Use only approved replacement blades.
Wear heavy gloves when you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Wedge a piece of wood into the deck to prevent the
movement of the blade.
6. Remove the mounting screw and spacer with a wrench or
socket.
7. Remove the blade.
CAUTION
CAUTION
WARNING
WARNING
WARNING
English
8. Install the new blade. Make sure that the arrows engage
the holes in the blade.
9. Put in the mounting screw and tighten it. Recommended
tightening torque: 33-37 NM.
Otherwise, obstacle or blade may fly and hit the user or
a person nearby, who may be injured, or may hit and
damage something.
9.3

STORE THE MACHINE

• Remove the safety key.
• Remove the battery pack(s).
• Clean the machine before storage.
• Make sure the motor is not hot when you store the
machine.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to your dealer.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
9.4

STAND THE MACHINE ON END

Figure 11.
It is necessary to remove the safety key and the battery pack
before putting the mower in vertical storage.
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
6. Put the grass bag on the inside of the deck and hide the
blade during the storage position to reduce the risk of
injury from touching the blade.
10

TROUBLESHOOTING

Problem
The handle is not
in position.
10
WARNING
WARNING
Possible cause Solution
The bolts are not Adjust the height
engaged correctly. of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.