Medel QUICK Bedienungsanleitung Seite 19

All manuals and user guides at all-guides.com
EN
With the unit switched off, press the "M" button and the last measured
value will automatically appear.
Press the "M" button again to view the other measured values.
Clear the memories
1. Press the "M" button (memory mode).
2. Hold the START/STOP button down for approximately 3 seconds and
all memories will be cleared.
3. The unit will emit a sound when the memories have been cleared.
4. Press the START/STOP button to turn the unit off.
The memory cannot be recovered once it has been deleted.
7. TROUBLESHOOTING
1. No power: Change the dead batteries with two new ones.
2. Nothing appears on the display:
Make sure the batteries have been set up in the right direction of polarity.
3. The measured values are too high or too low:
Blood pressure varies constantly.
The blood pressure value is affected by many factors: stress, the time of
measurement, how the cuff is wrapped around the wrist.
4. Although the batteries are in place, the display does not work when
the unit is switched on:
If the display does not come on, put the batteries back in or change them.
19