Time Display; Displaying Two Time Zones; Alarm - BASETech GB77 Bedienungsanleitung

All manuals and user guides at all-guides.com
• If no buttons are pressed within 60 seconds, the watch will automatically revert to the time
display.
Hold down the SEL button to move through the values more quickly.

12. Time display

If the watch does not display the time, keep pressing the MODE button until TIME is shown on
the display. The time and the date will be displayed automatically after three seconds.
a) Displaying two time zones
• Hold down the SEL button for approximately three seconds to display a second time zone.
• To configure the time for the second time zone, hold down the SET button for three seconds.
"HOLD TO SET" will be displayed while you hold down the button. Release the button when
"12H" or "24H" is shown on the display.
• To switch between 12 and 24-hour mode, press the SEL button.
• Configure the remaining settings (seconds, minutes and hours) as described in section 11
("Initial setup"). Use the SEL button to select the value and then apply the setting using the
SET button.
• Press the MODE button to exit the setting mode and save all settings.
• This feature is particularly useful for travellers or people that often make international calls.
b) Alarm
When the time is displayed, briefly press the SEL button to display the current alarm time
("ALARM" will be shown at the bottom of the display).
Setting the alarm time
• Hold down the SET button for three seconds. "HOLD TO SET" will be displayed while you
hold down the button. Release the button when the time is displayed and the minute value
flashes.
• Configure the minute value using the SEL button.
• Briefly press the SET button to go to the hour value. Configure the hour value using the SEL
button.
• Briefly press the SET button to go to the month value. Configure the month value using the
SEL button. Select "--" to skip the month setting.
37