Priming The Pump - Honda WH15XT Bedienungsanleitung

PRIMING THE PUMP

Before starting the engine, remove the filler cap from the pump
chamber, and fill the pump chamber with water up to its priming water
filling level. Reinstall the filler cap, and tighten it securely.
Operating the pump dry will destroy the pump seal. If the pump has
been operated dry, stop the engine immediately, and allow the pump to
cool before priming.
If the discharge hose must run across a roadway, the hose should
cross the roadway perpendicular to traffic flow. Also, heavy boards
should be placed next to the hose so the motor vehicle weight does not
shut off the discharge as vehicles cross over the hose.
Driving over a discharge hose while the pump is running, or even
possibly when the pump is stopped, may cause pump case failure.
BOARDS
DISCHARGE HOSE
PRIMING WATER FILLER CAP
OPERATION
PRIMING WATER
FILLING LEVEL
23