Echo MB-580 Bedienungsanleitung Seite 11

Before you start
5. Install packing (D) to swivel pipe (E).
6. Assemble swivel pipe to flexible pipe.
7. Assemble straight pipe (F) to swivel pipe.
8. Tighten the screw (G).
9. Pass throttle cable (H) through throttle cable guide loop.
10. Position handle (I) at a location suitable for comfortable op-
eration, and tighten knob.
11. Assemble one straight pipe to the other.
12. Put discharge tube (J) into rubber band (K).
13. Insert a clip (L) to the pipe.
14. Insert a pin (M) into the clip.
If you need to remove the clip, turn it by 90 degrees anti-
clockwise and pull it out.
15. Assemble curved pipe (N) onto straight pipe.
16. Insert a clip into the pipe.
9
NOTE