Bloom Diagnostics bloom lab Bedienungsanleitung Seite 11

Bloom Lab shows
recoverable error.
Bloom Lab shows fatal
error.
Bloom Lab does not work.
4-3-6-2 Bloom Lab IFU, 09.04.2020, V1.0
Bloom Test strip was inserted
earlier than expected.
QR code on the Bloom Test
strip cannot be read.
Bloom Test strip has been used
already or does not match the
information provided on the
registered test package.
Bloom Test strip was not
inserted properly.
Bloom Test strip was removed
during measurement.
Bloom Test strip inserted too
late for measurement.
The Bloom Lab is exposed to a
temperature above +40°C.
The Bloom Lab is exposed to a
temperature below +15°C.
Bloom Lab internal error, not
recoverable.
Bloom Lab has no power
supply.
Bloom Lab internal error.
Bloom Lab not responding.
Table N°3: Troubleshooting
Remove the Bloom Test strip from the Bloom Lab and follow
the steps according to the Bloom App.
Remove the Bloom Test strip from the Bloom Lab and follow
the steps according to the Bloom App.
Try inserting the Bloom Test slower or faster.
Remove the Bloom Test strip from the Bloom Lab and follow
the steps according to the Bloom App.
Remove the Bloom Test strip from the Bloom Lab and follow
the steps according to the Bloom App.
Re-insert the Bloom Test strip into the Bloom Lab and follow
the steps according to the Bloom App.
Please repeat the testing procedure by using a new test.
Information: When a Bloom Test strip is inserted later than
expected, the sample can not be evaluated.
Ensure an ambient temperature below +40°C. Take care that
the Bloom Lab is not exposed to direct sunlight.
Ensure an ambient temperature above +15°C.
Contact technical support for assistance.
Make sure that the Bloom Lab is plugged in as instructed.
Contact technical support for assistance.
Disconnect and reconnect the Bloom Lab from the power supply
and wait for the boot process to be fi nished.
EN
11