Handlebar And Flag Installation - Burley Bark Ranger Anleitung

Handlebar Installation/Adjustment
1. Insert handlebar into receiver, depress both yellow
handlebar receiver buttons and insert the handlebar past
the buttons. (Figure 22)
2. Release the buttons and slide the handlebar until it clicks
into place. (Figure 22)
3. The handlebar has two height settings. Depress each
handlebar receiver button to slide the handlbar to desired
setting (Figure 22). Ensure that both sides of handlebar are
in the same height setting.
4. Before use, push down and then pull up slightly on the
handlebar grip to ensure that the handlebar is locked
into place.
5. To remove handlebar, depress both buttons and slide
handlebar out completely.
Flag Installation
1. Insert the flag into the flag mount located on either
handlebar receiver. Ensure it is inserted completely.
(Figure 23)
10 ENG
Figure 22
Figure 22
®
Figure 23
PET TRAILERS
Figure 23