Setting Up The Bbq; Before Grilling; Operation - tepro DETROIT Bedienungsanleitung

t

Setting up the BBQ

Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
BBQ's stability.
– Check the stability of the screws prior
to each use. If necessary, tighten all of
the screws again to ensure the BBQ is
standing securely.
– When using the grill, please protect
the floor and surrounding walls from
possible soiling e.g. through grease
splashes.
• Before use, place the BBQ on an even,
sturdy surface outdoors.

Before grilling

• Prior to first use, wash the cooking grate
with warm soapy water.
• Pre-firing
Before you use the BBQ for the
first time, it needs to be conditioned
(pre-fired) for approx. 1-2 hours at a
temperature of 100° - 200°C.
This is necessary in order to make the
inside ready for barbecuing and to burn
in the heat-resistant paint on the outside.

Operation

Danger Risk of burning!
The BBQ, the charcoal and
BBQ meat become very hot
during use. Any contact can
result in serious burns.
– Keep sufficient distance from the hot
parts, since any contact can lead to
severe burns.
22
P180141_TEPRO_1037_Detroit_K_DE_GB_20180730.indb 22
– Always wear oven or BBQ gloves when
grilling. (Glove Category II with regard
to heat protection, e.g. DIN-EN 407)
– Use only long-handled utensils with
heat-resistant grips.
– Do not wear any clothing with wide
sleeves.
– Use only dry lighters or special fluid
lighters compliant with EN 1860-3 as
firelighters.
1. Open the cover and remove the
grates (5).
2. You can use both sides or just one
side of the grill body (8). Place 3-4
solid firelighters in the middle of the
grill body side that you wish to use.
Pay attention to the manufacturer's
instructions on the packaging. Light
the firelighters with a match.
3. Layer maximum 3 kg of charcoal
around the firelighters.
4. Prior to first use,the grill must be
prefired for minimum 30 minutes.
Refer to the "Before Grilling" section.
5. As soon as the charcoal is glowing,
distribute it evenly in the grill body (8).
To do this, use a suitable fireproof tool
with a long, fireproof handle.
6. Slide the grate onto the guide rails on
the windshield at the desired height.
7. Do not cook before the fuel has a
coating of ash.
30/7/2018 6:03 PM