Setting Up The Bbq; Before Grilling; Operation - tepro ATLANTA Bedienungsanleitung

t
6. Hook the grill grates (10) onto
the rails on the wind shield at the
desired height.
7. The BBQ is now ready for use.
8. Dismantling is carried out in reverse
order.
Important: All screws must be tight-
ly fastened.

Setting up the BBQ

Attention Risk of damage!
During use, the screws can
loosen slowly and impair the
BBQ's stability.
– Check the stability of the screws pri-
or to each use. If necessary, tighten
all of the screws again to ensure the
BBQ is standing securely.
– When using the grill, please protect the
floor and surrounding walls from pos-
sible soiling e.g. through fat splashes.
• Before use, place the BBQ on an
even, sturdy surface outdoors.

Before grilling

• Prior to first use, wash the BBQ grate
thoroughly in warm soapy water.
• Before you use the BBQ for the first
time, it needs to be conditioned (pre-
fired) for at least 30 minutes at a tem-
perature of 100°C - 200°C.
16
P180209-TEPRO_Atlant_00299-1_K_DE_GB_20181114.indd 16

Operation

Danger Risk of burning!
The BBQ, the charcoal and
BBQ meat become very hot
during use. Any contact can
result in serious burns.
– Keep sufficient distance from the hot
parts, since any contact can lead to se-
vere burns.
– Always wear oven or BBQ gloves when
grilling. (Glove Category II with regard
to heat protection, e.g. DIN-EN 407.
Glove must match the PSA regulation.)
– Use only long-handled utensils with
heat-resistant grips.
– Do not wear any clothing with wide
sleeves.
– Use only dry lighters or special fluid
lighters compliant with EN 1860-3 as
firelighters.
1. Remove the BBQ grates (10).
2. Place 3-4 solid firelighters in the mid-
dle of the fire bowl (7). Pay attention
to the manufacturer's instructions on
the packaging. Light the firelighters
with a match.
3. Layer a maximum 5 kg of charcoal
around the firelighters.
4. Prior to first use, the BBQ must
be heated up and glow for at least
30 minutes. See Before grilling.
5. As soon as the charcoal is glowing,
spread it evenly over the fire bowl. To
do this, use a suitable fireproof tool
with a long, fireproof handle.
6. Hook the grill grates (10) onto the
rails on the wind shield at the desired
height.
14/11/2018 10:10 AM