Throttle Trim; Steering Trim; Install Your Receiver; Receiver Connection And Binding - Modster Vector SR48 Brushless Betriebsanleitung

Manual - Vector SR48 Brushless

Throttle Trim

The throttle trim dial is used to adjust the
throttle trim when the throttle stick is released
(neutral position). This is typically used to adjust
the brakes. Rotating the dial causes the throttle
trim (the throttle position at rest) to be
changed.

Steering trim

The steering trim dial is used to adjust the
steering trim when the wheel is centered.
Rotating the dial changes the steering trim
(the steering at rest position).
Normally, the steering trim is adjusted until the
vehicle tracks straight.

Install Your Receiver

Install the Receiver in your vehicle using
douple-sided Velcro. This will hold the
receiver in place and help isolate it from
vibrations. Mount the antenna up and away
from the vehicle in an antenna tube. The
higher up the antenna is, the better signal it
will receive.
CAUTION: Dont cut the antenna.

Receiver Connection and Binding

Binding is the process of programming the receiver to recognize the GUID (Globally Unique
Identifer) code of a single specific transmitter. When a receiver is bound to a transmitter, the
receiver will only respond to that specific transmitter. If you need to rebind for any reason,
please follow these steps:
1. Switch the transmitter off.
2. Power on the receiver, then turn on the transmitter within 5 seconds.
3. The receiver LED will flash for 3-8 seconds to bind automatically.
4. After the receiver LED stop flashing, it means the binding is done.
42 www.modster.at