Modster Vector SR48 Brushless Betriebsanleitung Seite 35

Manual - Vector SR48 Brushless
Troubleshooting Guide
Problem
Boat tends to dive
in water or takes on
water
Boat tends to turn
in one direction
Rudder does not
move
Controls reserved
Motor or ESC
overheats
Motor power pulses
then motor loses
power
www.modster.at
Possible Cause
Boat hull is not completely closed
Center of gravity is too far forward
Trim tabs are angled incorrectly on
the back of the boat
Rudder or rudder trim is not
centered
Vertical fins of trim tabs are angled
incorrectly
Rudder, linkage or servo is
damaged
Wire is damaged or connections are
loose
Transmitter is not bound correctlly
or incorrect boat was selected
BEC of ESC is damaged
ESC is switched off
Transmitter setting are reversed
Blocked water cooler tubes
ESC uses default soft Low Voltage
Cut off
Weather conditions are too cold
Battery: cold, worn out or damaged
Battery Crating too small
Solution
Dry out the boat and ensure the
hatch is fully closed on the hull
Move batteries back in the hull
Angle each trim tap up a little bit
to lift the bow or down to lower it
Repair rudder or adjust rudder
and rudder trim
Angle the fins a little bit right or
left
Replace or repair damaged parts
and adjust controls
Do a check of wires & connections,
connect or replace as needed
Rebind or select the correct boat
in transmitter
Replace ESC
Power on ESC
Control Direction Test and adjust
controls
Clean or replace water tubes
Recharge boat battery or replace
it
Postpone until it is warmer
Replace it
Use recommended battery
35