General Information - Deltaplus TC007 Bedienungsanleitung

operations, the descender may get hot enough to damage the
line.
Figure 6: RIGGING FOR RESCUE
Double rope length should be employed.
Figure 7: HAULING AND PROGRESS CAPTURE
SYSTEMS
Hauling from a fixed position with TC007 is easiest done either
with a 1:1 counterweight or for heavier loads by means of a 3:1
mechanical advantage pulley system (fig.7). Ergonomically
easier pulling from above may be attained by employing
another redirectional pulley on the free end of the rope.
Transition from ascent do descent is done by removing the
pulley system, clipping the rope in a redirectional carabiner
above the TC007 and starting to lower (fig. 4/B).
Figure 8: WORK ON WIND TURBINES
Use two TC007 as a descender devices and a positioning
device around the blade.

GENERAL INFORMATION

Regular examination:
Do not hesitate to retire the device if it shows signs of wear or
after a major fall or a major impact. They could cause internal or
invisible damage that may significantly weaken its strength. In
case of uncertainty treat the device as damaged or consult
DELTA PLUS GROUP.
Regular periodical inspections should be carried out by an
authorised person at least once a year. For this purpose an
inspection record should be established (see the backside of
these instructions). Furthermore, we would sincerely
recommend one set of equipment is used by one person only as
its history of use is best traced and understood in this way.
Before each use, it is obligatory to check the device and verify
that all its components (handle, jamming cleat, flanges) are
faultless and in good working condition.
Packing, storage, maintenance and cleaning
Each product is packed with its INSTRUCTIONS FOR USE.
Proper maintenance and storage are imperative to ensure