osann BeLine SP Gebrauchsanleitung Seite 15

Your Group 1-2-3 booster seat
(2)
1. Height adjustable head support
2. Diagonal belt guide (x2 - use without harness)
3. Safety harness
4. Diagonal belt guide (x2 – use with harness)
GB
5. Harness buckle
6. Height reduction cushion (depending on the model)
7. Harness adjustment strap
8. Instruction manual pouch (depending on the model)
9. Crotch strap
10. Seat
11. Safety covers(x2)
12. Back
13. Metal retainer clip
14. Harness adjuster button
Assembling the booster seat
Place both tongues on the back into the notches on the seat (3), and then raise the
back up vertically (4).
Press firmly on the back to ensure that both tongues of the back of the seat are
securely in place (5). The tongues on the back must be pushed down as far as they
will go into the seat.
Installation with the harness
Gr. 1, from 9 to 18 kg (from approximately 9 months to 4 years)
Ensure that the harness of your car seat is suitable for the size of your child before
installing it in your vehicle.
The shoulder harnesses can be set to three heights and must be passed through
the holes closest to the shoulders of your child. If the shoulders of your child are
between two pairs of holes, use the higher ones.
To adjust the height of the shoulder straps of the harness, detach the ends of the
strap from the metal retainer on the back of the car seat (6). Pull the ends of the
straps through the back, the sheath and the cover (7). Pass the sheathes through
the back and the cover (8), then place them at the desired height using the same
slits in both the cover and the actual seat (9).
Place the shoulder straps through the sheathes, the cover and the seat (10) and
reattach them to the metal retainer clip (11). Ensure that the straps are not twist-
ed.
• Loosen the harness by pressing on the adjuster under the front of the seat, pull
the shoulder straps under the safety sheathes pulling on the straps at the same
time.
• Tighten the harness by pulling on the adjustment strap at the front of the car
seat. It is not necessary to press the adjuster.
15
User guide - GB