Inhaltsverzeichnis
Werbung
08-8
MIDI Implementation
Page 5
FRONT PANEL SELECTABLE FUNCTIONS (ON PAGE TWO OF FRONT PANEL)
NOTE: Functions must be enabled on source AND destination machines to work.
Switch
A
Function
Enable/Disable program change and program dump.
Power-On default: disabled.
B
Enable/Disable Pitch bend and modulation controls.
Default: disabled.
c
OMNI ON/OFF. Toggle OMNI status. Power-On default is OMNI ON
(led is lit.) (see t-lODE)
D
Channel display/select. Press and hold down D button to display
or select the Basic Channel.
WRITE
Dump current STORED program to MIDI. NOTE: SWITCH
"A",
"PROGRAM
ENABLE", MUST BE ENABLED FOR A DUMP TO OCCUR.
TRACK
Sequencer Re-Enable
!
Turn off MIDI Notes.
IMPORTANT: The OB-8 cannot RECEIVE MIDI info and be run by the
DSX sequencer simultaneously
(due to hardware design.)
So, to
prevent MIDI data errors, the sequencer is DISABLED upon
receiving any data from MIDI IN. This condition is displayed by
the TRACK led on page
2.
When you no longer wish to use the OB-
8
as a receiver, and you want to use the DSX, disconnect MIDI IN
and press the TRACK button. The led will go out, the sequencer
will work normally, and any notes turned on by MIDI will be
turned off.
Power-On default: TRACK light off, Sequencer Enabled.
Oberheim Electronics, Inc.
Los Angeles, CA 90064 USA
p/n 950028
Werbung
Inhaltsverzeichnis
