Inhaltsverzeichnis
Werbung
Using the OB-8 MIDI Interface
Page 2
MIDI SWITCHES AND FUNCTIONS
All
MIDI SWITCHES are located in the PAGE 2 feature of the
OB-8.
Enter PAGE 2 by rapidly pressing the PAGE 2 switch twice.
The led
for
the PAGE 2 switch will light signifying that you are in PAGE
2. Most of the MIDI related switches are located in the programmer
section.
GROUP
B
C
~@
~~
~~~
D
(IJ
~
~
PROGRAM
I
2
3
4
5
6
7
8
IJRITE/RESET
D C3El Cl C3
ë)
t:l t:3 ~
(Figure 2.)
PROGRAM ENABLE / DISABLE -- SWITCH "A" (Page 2)
This switch enables and disables two patch related functions: patch
select, and patch data transfer.
v~en
the OB-8 is powered up these
functions are disabled.
SELECTING PATCHES -- In PAGE 2 on both OB-8
I
s, press the A switch.
The A led will light,
indicating the ability to
transmit/receiva
program
information.
Selecting a patch program in PAGE l on the
Master OB-8 will select the same patch program on the Slave
OB-8.
(EXCLUDING SPLITS
&
DOUBLES).
PATCH TRANStHT -- "WRITE/RESET" SWITCH (Page 2)
The
program
enable switch also allows you to
transfer
patches
from
the Master OB-8 to the Slave OB-8.
(NOTE: Memory
Protect
must
be
off on the Slave OB-8.)
In PAGE l on the Master
OB-8,
select patch D-l.
Now, enter Page 2 and press the WRITE button on
the Master OB-8.
After a short delay, the WRITE led will light,
indicating that the program Patch D-l has been transferred from
the memory of the Master OB-8 to memory location D-l in the Slave
OB-8.
To play this patch on the Slave OB-8, you must return to
PAGE l and re-select Patch D-l, or select a different patch on the
Master OB-8 then select D-l.
Now both OB-8's will play Patch D-l.
PITCH BEND AND MODULATION lEVER
ENABLE / DISABLE -- "B" SWITCH (Page 2)
When the OB-8 is powered on, the pitch bend and modulation levers
are not sent or received over MIDI (disabled). They must be enabled
on both units each time power is turned on.
In
PAGE
2 on both OB-8's,
press the B switch.
The B led
will
light,
indicating
the
ability
to transmit
and
receive
pitch
behd/modulation information.
When the Slave OB-8 receives
pitch
bend/modulation information, it uses that information based on the
settings on it's own Performance/Modulation Panel.
In other
words, if the slave machine is set to bend a semi-tone, it will
bend at that interval regardless of the bend setting of the master
machine.
Oberheim Electronics, Inc., Los Angeles, CA. 90064 USA
p/n 950029
Werbung
Inhaltsverzeichnis
