Atag BIH064 EV-Serie Bedienungsanleitung Seite 40

USE
• Never use pans with a misshapen base. A hollow or rounded base can interfere with
the operation of the overheating protection, so that the appliance becomes too hot.
This may lead to the glass top cracking and the pan base melting.
• Damage arising from the use of unsuitable pans or from boiling dry is excluded from the
guarantee.
Minimum pan diameter
• The diameter of the bottom of the pan must be at least:
10 cm for zone ø 16 and ø 17.5
▷
11 cm for zone 21.5 cm and zone 19 x 21 cm
▷
▷ 13 cm for zone ø 26.5 cm
23 cm for connected Bridge zones
▷
• You will achieve the best results by using a pan with the same diameter as the zone.
If a pan is too small the cooking zone will not work.
Pan move function
The hob has a pan move function. All settings that belong to a cooking zone (power level, timer
etc.) can be moved to another cooking zone. To move the settings; touch and hold the cooking
zone key for at least 3 seconds. A single beep sounds. Touch the cooking zone key of which you
want to move the settings to. Put the pan on the new selected cooking zone.
We recommend that you lift pans and not move them over the hob.
You can also swap two pans at the same time.
Make sure the bottom of the pan and the surface of the cooking zone are clean and dry.
Pan detection
The cooking zone automatically detects a suitable pan placed on a cooking zone. The cooking
zone display lights up. A power level can be set.
• If there is no (suitable) pan on a cooking zone, the pan detection symbol shows when you
set a power level. The symbol disappears when a suitable pan is put on the cooking zone.
• If you remove a pan from the cooking zone during cooking, the pan detection symbol
shows. The cooking zone switches off. The symbol disappears when you put the pan back.
The cooking zone switches on again with the power level set before.
EN 10