Bosch sensixx B35L Gebrauchsanleitung Seite 14

All manuals and user guides at all-guides.com
en
Cleaning & Maintenance
Always unplug the appliance from the mains
supply before carrying out any cleaning or
maintenance operation on it.
1. After ironing, pull out the plug and allow the
appliance to cool down before cleaning.
2. Wipe the housing, handle and iron body with a
damp cloth.
3. If the soleplate is soiled with dirt or scale, clean it
with a damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (D)
1. Always allow the appliance to cool down before
storing it.
2. Set the main power to the "0" position and
disconnect the mains cable.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the water tank and store the mains cable on
the cord rewind facility. Tidy the steam hose on the
handle of the iron using the cord clip provided (12*).
Do not wrap the cords too tight.
* Depending on the model
Fabric protection soleplate
cover (E)
(depending on the model)
The fabric-protection soleplate cover is used for steam-
ironing delicate garments at maximum temperature
without damaging them. Use of the soleplate cover
also does away with the need for a cloth to prevent
shine on dark materials.
It is advisable to first iron a small section on the inside
of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place the tip
of the iron into the end of the soleplate cover and pull
the elastic strap over the lower rear of the iron until
it fits tightly. To release the soleplate cover, pull the
elastic strap and remove the iron.
The fabric-protection soleplate cover may be purchased
from the customer service or specialist shops:
Accessory code (After-
sales)
571510
464745*
* Cork handle iron
14
Name of accessory
(Specialist outlets)
TDZ2045
TDZ2520*
"Calc'n clean" (F)
Cleaning the Boiler
To extend the life of your steam generator and to avoid
any build up of scale, it is essential that you rinse out
the boiler after several hours of use (approximately afte
50 hours). If the water is hard, increase the frequency.
Do not use descaling agents for rinsing out the boiler,
as they could damage it.
1. Check that the appliance is cold and unplugged for
more than 2 hours, and that the removable water
tank (1) is empty.
2. Place your appliance on the edge of your kitchen
sink.
3. Remove the plastic cover located on the bottom of
the appliance by turning it to the
4. Unscrew the boiler drainage plug located on the
bottom of the appliance using a coin.
5. Holding your steam generator in upside down
position, and using a jug, fill the boiler (in the base
unit) with 1/4 litre of water
6. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To obtain
the best result, we recommend that this operation is
done twice
Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug with
a coin.
8. Insert and close the plastic cover by turning it to the
position.
Automatic clean warning
(depending on model)
Pilot light (3) will flash indicating that boiler must b
rinsed. To do this, follow the procedure described in
the section above.
To reset "Calc'n clean" pilot light and counter, switch
the station off twice, keeping it off during at least 30
seconds each time.
position.
T