Bosch sensixx B35L Gebrauchsanleitung Seite 13

All manuals and user guides at all-guides.com
the correct temperature by ironing a small section
not usually seen when worn
Ironing with steam (B)
1. Turn the temperature selector (13) to the required
setting.
2. Set the amount of steam to suit your needs, using
the variable steam control (5) (depending on the
model).
For normal use, please choose one of the following
recommended settings:
Temperature
•
••
•••
3. Press the steam release button to release steam.
Attention:
1. When ironing on a lower temperature setting "•".
• If the appliance has variable steam control (5), set the
variable steam control to its lowest position
• If the appliance does not have variable steam con-
trol, press the steam release button only for a few
seconds at a time when ironing at lower tempera-
tures.
In both cases, if you find that water is dripping out
of the soleplate, set the temperature selector (13) to
a higher position (take care that the garment can be
ironed on this heat temperature setting).
2. At the beginning of each use, it is possible that
drops of water will be dispensed alongside steam.
Therefore, it is advisable to try the iron on the ironing
board or a piece of cloth to start with.
Important:
• The steam hose may get hot if you are ironing for
long periods.
Cork handle iron
(depending on the model):
To get permanent steam, press the lock
button (16) and slide it backwards until it locks.
To switch off the permanent steam, slide the lock
button forward.
Ironing without steam
1. Begin ironing but without pressing the steam release
button (15).
Vertical steam (C)
1. Set the temperature control to the "•••" or "max"
position.
2. You can steam iron curtains and hanging garments
(jackets, suits, coats...) by placing the iron in a
vertical position and pressing the steam release
button (15).
Never direct the steam jet at garments that are
being worn.
Never aim the steam at people or animals.
h) Press the steam release button (15) and gently
shake the iron. Boiling water and steam will come
Steam setting
out, carrying scale and or deposits that might be
there. This could take approximately 5 minutes.
i) Set the temperature selector (14) of the iron to the
"max" position, without pressing the steam release
button (15). The water in the steam chamber will
start evaporating. Wait until all the water inside the
chamber has been evaporated.
j) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
.
"Energy saving" button
(depending on the model)
If the "Energy saving" button (6) is switched on, you
can save up to 25% of the energy and 40% of the
water consumption, and still have a good ironing result
for most of your garments. It is advisable to use the
normal energy setting only for thick and highly wrinkle
fabrics.
Intelligent steam
(depending on the model)
This system has intelligent steam control, which, after
releasing the steam release button (15), provides a
small amount of additional steam.
The additional steam can always be stopped by briefly
pressing the steam release button once again.
Auto shut-off
(depending on the model)
If during ironing the steam release button (15) on the
handle of the iron is not pressed for a certain length of
time (8 minutes), the steam station will automatically
switch off.
The "Auto shut-off" pilot lamp (4) will flash when aut
shut-off has been activated.
To switch the steam station back on, press the steam
release button again, and wait until the "Auto shut-off
pilot lamp remains lit continuously.
en
13