Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C
LIMATIC CLASS
SN
N
ST
T
3. Installation
All dimensions in these chapters are given in millimetres.
Insert the plastic wall spacers
appliance to ensure a ventilation gap between the appliance and the wall (see also
chapter 3.2.2 W
The minimum distances required for proper ventilation can be found in chapter
3.2.3 V
ENTILATION
3.1 Unpacking and positioning
WARNING! While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
waste management.
2. Remove all packaging materials.
3. The accessories of your appliance can be protected from damage due to trans-
portation (adhesive tapes etc.). Remove such tapes very carefully. Remove re-
mains of such tapes with a damp cloth using lukewarm water and a mild detergent
(see also chapter
nents of the back of the appliance!
4. Install the appliance in a suitable position with an adequate distance from sources
of heat and cold.
5. If installation near a heat source is unavoidable, use a suitable insulation plate or
keep the following minimum distances to the heat source:
Depending on model.
19
+10
+16
+16
+16
in the corresponding openings on the back of the
19
)
ALL SPACERS
.
CLEANING AND MAINTENANCE
A
MBIENT TEMPERATURE
0
→+32
0
C
0
→+32
0
C
inner home temperature
→+38
C
inner home temperature
0
0
0
→+43
0
C
inner home temperature
). Never remove any compo-
53
e.g. unheated cellar
Werbung
Inhaltsverzeichnis
Fehlerbehebung
