Thermostat Control; Filling The Water Reservoir - Beem PYRAMID Bedienungsanleitung

25

Thermostat Control

The thermostat control (9) is used to switch the device on and off and set the temperature of the
water. The following settings can be selected with the thermostat control:
O
The device is switched off.
Warm water
Hot water
Boiling water
(11) lights up as soon as the heating element of the device starts heating the
The control lamp
water. The control lamp lights up at intervals when the water is being kept warm and when boiling
at intervals.
Removing / Attaching the Lid of the Water Reservoir
1. Hold the lid (4) by the lid handles (15).
If the device has been in operation, use potholders or similar gloves as the lid might be hot.
Always allow the device to cool down before filling it again.
2. To remove the lid, rotate it anticlockwise towards
3. To close the lid, place it on and rotate it clockwise towards
4. Place the teapot (3) on the lid. This closes off the device at the top.

Filling the Water Reservoir

Only ever fill the water reservoir (7) with fresh, clear tap water. Do not pour in any other
liquids.
1. Remove the lid (4) (see the "Removing / Attaching the Lid of the Water Reservoir" section).
2. Pour the desired quantity of water (maximum 4 litres) into the water reservoir. Note the
MAX marking.
3. Close the lid (see the"Removing / Attaching the Lid of the Water Reservoir" section).
Operating the Discharge Tap
There are two possible ways of removing the water from the water reservoir (7) using the dis -
charge tap (12).
Touch Mode (Picture A1)
1. Press down the lever (13) and keep it pressed down. The discharge tap opens and water flows
out.
2. Let go of the lever when the quantity of water you want has been removed. The discharge tap
closes again.
and then lift it off.
. The lid is now locked in place.
EN