Components Of The Saunum Base / Base Short Device - Saunum BASE Bedienungs- Und Installationsanleitung

Figure 1C – Components of the Saunum BASE / BASE Short device.
ADDITIONAL AIR VALVE
BOTTOM
TRAY
SALT BALLS
GRILLE MOUNTING
BOLT
16
GLASS FRONT PANEL
SWITCH
AIR DISCHARGE AND GRILLE
The Device works most efficiently when the
edge of the upper airing vent opening is
adjacent to the ceiling of the steam room
(model with a protective grille). If the De-
vice is not equipped with a protective grille,
the Device should be installed so that the
upper edge remains 80–100 mm below the
ceiling. The lower edge may not be closer
than 100 mm to the floor to prevent the
water on the floor from coming into contact
with the electrical wiring of the Device.
Figure 1D – Saunum BASE / BASE Short
model installation.
The Device is designed for wall mounting
using the hanging strips included in the
set. The wall in the installation spot must
be able to carry the weight of at least 35 kg
and allow the supplied hanging strips to be
fastened with screws. The hanging strips
are attached to the wall of the steam room,
each with at least two screws. The Device is
then lifted onto the wall so that both the
upper and lower strips slide between the
strips attached to the back of the Device.
17