Saunum BASE Bedienungs- Und Installationsanleitung Seite 13

Figure 2C – Recommended instal­
lation of the Saunum BASE S model
using a hanging strip.
1. Install the strips supplied with the
Device on the wall. Use anchors if
necessary.
2. Hang the Device on the wall- mounted
strips. Make sure that the eyelets on
the back of the Device rest equally on
both slats. (If necessary, use a spirit
level to ensure that the Device is level.)
3. Check the Device for any external
damage. It is forbidden to use a dam-
aged Device!
4. Before using the Device, cover all un-
covered openings using the specified
aluminium tape to do so.
Adjust the sides
and top of the cap
Opening under the cap after
adjusting the telescopic cap
24
5. Place the salt balls. The salt balls are
placed in the Device after it has been
mounted on the wall. To place the balls,
open the lower grille by removing the
Screws (min 2 pcs)
two hand-turned bolts. Place the balls in
their slots on the tray.
Salt balls
Fastening bolt to
remove the grille
25