Dimensions / Installation; Mounting The Wall Bracket; Mounting The Radio Adapter Inside A Instantaneous Water Heater; Battery Replacement - clage FXS Next Gebrauchs- Und Montageanleitung

4. Dimensions / Installation

See figure A1 (dimensions in mm) .

Mounting the wall bracket

See figure A3 or A4 (dimensions in mm) .

Mounting the radio adapter inside a instantaneous water heater

With the CFX, DFX and DSX Touch models, the radio adapter is already
installed at the factory.

5. Battery replacement

Replace the batteries with new AA-batteries when the battery symbol
appears (fig . A2) .
• Do not use rechargeable batteries!
• Non-rechargeable batteries are not to be recharged .
• Different types of batteries or new and used batteries are not to be
mixed .
• When replacing the batteries, observe the correct polarity .
• Before assembling the transmission unit disconnect the instantaneous
water heater from the mains supply!
• Pay attention to the proper position of the connector!
• The connector has to be fitted into the notch properly .
1 . Open the instantaneous water heater according to the manual of the
appliance .
2 . Plug the radio adapter onto the electronics (see fig . A5 or A6) . If nec-
essary, remove the electronics cover first .
3 . Replace the bonnet and fasten it .
Disposal
Batteries may contain environmentally hazardous substances . Therefore,
used batteries must be disposed of at special collecting points and not
be mixed with general household waste .
At the end of the remote control's lifetime, the batteries must be dis-
posed of separate from the appliance .
13
EN