Inhaltsverzeichnis
Werbung
4.1 Connection with a push-button
To operate the sound module with a push-button, please refer to fig. 2 (marking A).
-
After pushing the button, the first song is played (optionally with synchronous movement).
-
After pushing the button, the second song is played (optionally with synchronous movement).
-
After pushing the button, the third song is played (optionally with synchronous movement).
-
After pushing the button, the first song is played again (optionally with synchronous movement).
-
Etc.
Note: If you press the button while a song is playing, the sound module stops playing.
4.2 Connection with an on-off switch
To operate the sound module with an on-off switch, please refer to fig. 2 (marking B).
-
The sequence is the same as when using a push-button, but the songs are played automatically every two to three
minutes.
4.3 Connection of an external loudspeaker
The sound module is equipped with an output for an external loudspeaker with electrical values of 8 ohm impedance at least
and min. 1 watt power (can be purchased in a specialized shop for electronics). In case you connect an external loudspeaker
the integral loudspeaker will be switched off.
1. Please pull the sound module's short blue cable out of the next socket to the right.
2. Insulate the blue cable to avoid any contact with other cables.
3. Mount the external loudspeaker to the intended place.
4. Lay the two wires of the external loudspeaker to the sound module.
5. Connect the two wires to the two sockets according to fig. 3.
4.4 Volume adjustment
The sound module is equipped with a volume control for the sound. The adjustment is valid both for the integral loud-
speaker and for an external loudspeaker.
To adjust the volume, use a slotted screwdriver and proceed as follows (see fig. 4):
-
Increase volume: Turn the poti to the right.
-
Reduce volume: Turn the poti to the left.
5. Trouble-shooting
All Viessmann products are produced with high quality standards and are checked before delivery. Should a fault occur
nonwithstanding, you can do a first check.
Please check first the power supply and the wiring.
No sound from the module. No sound from the external loudspeaker.
-
Sound module has to be connected acc. to fig. 2. If the synchronous input is not connected as shown in the figures,
playing of the sound will not be possible!
-
Turn the poti to the right.
-
Please make sure that the small blue plug at the housing of the sound module is removed from the socket and is
insulated.
Connect the external loudspeaker as shown in fig. 3.
If you are unable to find and fix the cause for the problem please contact our service department (service@viessmann-
modell.com). Please send the item to the Viessmann service department for check and repair only after consultation.
6. Technical data
Operation voltage:
Operation current:
Insulation:
Temperature/humidity (operation):
Temperature/humidity (storage):
Weight:
Dimensions:
10 – 16 V AC ~
14 – 24 V DC =
ca. 150 mA
IP20
0 – 40° C
-10 – 60° C
ca. 50 g
L 8.8 x W 5.3 x H 2.2 cm
5
Werbung
Inhaltsverzeichnis
