Inhaltsverzeichnis
Werbung
When turned on, the chicken's cackle is played continuously.
By pushing the button marked with B in fig. 2, the chicken's cackle is complemented by the sound of a barking dog.
Once the scene with the barking dog is finished and you push button B again, the chicken's cackle is complemented by
the cry of a bird of prey.
After this scene is finished, pushing the B key again adds a rooster and a shot of a rifle to the chicken cackling sound.
The scenes can be played in any order. It is, however, not possible to switch to the next scene while one is playing.
4.2 Automatic mode
Connect the sound module acc. to fig. 3.
After toggling the switch (A) the chicken cackling sound is played continuously. When toggling the switch (B), the scenes
dog, bird of prey and shooter (as per chapter 4.1) are played consecutively every 2 – 3 minutes. In order to leave the
automatic mode, you just flip the switch again.
4.3 Connection of an external loudspeaker
The sound module is equipped with an output for an external loudspeaker with electrical values of min. 8 ohm impedance
and 1/2 a watt power at least (can be purchased in a specialized shop for electronics). In case you connect an external
loudspeaker the incorporated loudspeaker will be switched off.
1. Please pull the short blue cable from the sound module out of the socket right beside it.
2. Insulate the blue cable to avoid any contact with other cables.
3. Mount the external loudspeaker at the intended place.
4. Install the two wires of the external loudspeaker to the sound module.
5. Connect the two wires to the two sockets according to fig. 5.
You can use plugs and sockets for the connection, e. g. Viessmann item 6875 (orange plug) and item 6884 (orange
socket).
4.4 Volume adjustment
The sound module is equipped with a volume control for the sound. The adjustment is valid both for the integrated loud-
speaker and for an external loudspeaker.
To adjust the volume, use a slotted screwdriver and proceed as shown in fig. 6:
- Increase volume: Turn the poti to the right.
- Reduce volume: Turn the poti to the left.
5. Trouble-shooting
All Viessmann products are produced with high quality standards and are checked before delivery. Should a fault occur
nonwithstanding, you can do a first check.
Please check first the power supply and the wiring.
No sound from the module. No sound from the external loudspeaker.
- Turn the poti to the right.
- Please make sure that the small blue plug at the housing of the sound module is removed from the socket and is in-
sulated.
Connect the external loudspeaker as shown in fig. 5.
If you are unable to find and fix the cause for the problem please contact our service department (service@viessmann-
modell.com). Please send the item to the Viessmann service department for check and repair only after consultation.
6. Technical data
Operation voltage:
Operation current:
Insulation:
Temperature/humidity (operation):
Temperature/humidity (storage):
Weight:
Dimensions:
10 – 16 V AC ~
14 – 24 V DC =
ca. 150 mA
IP20
0 – 40° C
-10 – 60° C
ca. 50 g
L 8.8 x W 5.3 x H 2.2 cm
5
Werbung
Inhaltsverzeichnis
