ATOMSTACK P7 Serie Installationshandbuch Seite 13

1
2
Step 4
1. According to the figure, insert the laser module into
the X-axis slide rail block vertically along the dotted line,
and then tighten the torx handle. The torx handle can be
adjusted to move the laser modle up and down. The
limit position for the laser module to move up is where
the bottom of the laser is level with the bottom of the
slider. The maximum downward movement distance for
the laser module is 72mm.
2. According to the figure, paste the foam along the
dotted line to the stand of the engraver.
Components required
Foot pad foam
laser module
components