Beem ESPRESSO-SELECT Bedienungsanleitung Seite 38

EN
Problem
The brewing process
cannot be started.
Water runs out of the
device.
The espresso / coffee
runs along the outside
of the portafi lter (d).
Despite a pumping
noise, no water comes
out of the device.
The espresso / coffee
runs very slowly into
the cup.
A large amount of
steam is produced in
the brewing process.
During use, an
unpleasant smell is
detected.
05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 38 05025_Inlay_DE-EN-FR-ES-IT_A5_V3.indb 38
Possible cause
The device has not yet reached
the correct brewing temperature.
There is too much water in the
water tank (h).
The steam power control (3) is
not in the position.
The drip tray (e) is full.
The portafi lter is not inserted
correctly.
The rim of the portafi lter
is contaminated with
espresso / coffee powder.
There is no water in the water
tank.
The water tank is inserted
incorrectly.
The espresso / coffee powder is
pressed too fi rmly.
The espresso / coffee powder is
too fi nely ground.
The device is furred up.
The device is furred up.
The device is being used for the
fi rst time.
The device has previously been
descaled.
Fix
Wait until the device has heated
up or cooled down suffi ciently.
You can speed up the cooling
process by fl ushing through the
steam nozzle.
Do not overfi ll the water tank!
Always move the selector switch
to the position when there is
no vessel under the portafi lter
outlet or the steam nozzle (6).
Empty the drip tray.
Make sure that it fi ts correctly.
Clean the portafi lter and the
sieve insert (b / c).
Fill the water tank.
Take out the water tank and
reinsert it. Make sure that it fi ts
correctly.
Only press down the espresso /
coffee powder lightly.
Use espresso / coffee powder
with a coarser grind.
Descale the device.
Descale the device.
A smell often develops when
new devices are fi rst used. The
smell should disappear once the
device has been used several
times.
Rinse out the device with fresh
water.
38
29.01.2021 14:40:57 29.01.2021 14:40:57