EBECO EB-Therm 55 Handbuch Seite 23

3. Connect power, voltage 230 VAC,
load and floor sensor cable.
Any extension to the floor sensor ca-
ble must be by means of high-voltage
current. Protective conductor for
incoming feed and for heating cable
is connected with a connection clip in
the box. See wiring diagram below.
4. Insert the thermostat into the ap-
pliance box and screw tight with the
existing screws.
5. Read the How the thermostat
works/Regulating functions section on
how to set the regulating functions.
6. Mount frame, front and knob.
7. If the thermostat is mounted in
a multi-compartment frame, the
internal corners of this frame must be
removed.
N
L
LOAD
LOAD
230 V
21