Zipper Maschinen ZI-STE1800IV Betriebsanleitung Seite 39

22 DISPOSAL
23 TROUBLESHOOTING
Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Always stop the machine before carrying out troubleshooting work
and secure it against unintentional restarting.
Fehler
The engine doesn't start
Engine starts and stops
immediately
Machine works with
interruptions (stutters)
Oil level indicator light
lights up
Run light does not light up
Overload indicator light
lights up
ZIPPER MASCHINEN GmbH
ZI-STE1800IV
Observe the national waste disposal regulations. Never dispose of the
machine, machine components or equipment in residual waste. If necessary,
contact your local authorities for information on the disposal options
available.
If you buy a new machine or an equivalent device from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.
Mögliche Ursache
 Incorrect startup sequence
 Insufficient pulling speed of
recoil starter handle
 Gasket damaged
 Air filter dirty
 Lack of fuel supply
 Fuel line fault
 Engine flooded
 Spark plug loose
 Spark plug damaged
 Spark plug cap not plugged in
 No ignition spark
 Incorrect fuel
 Fuel tap closed
 Damaged magneto
 Not enough engine oil
 Incorrect carburetor setting
(idle speed)
 Carburetor is incorrectly
adjusted
 Spark plug is sooted
 Not enough/ no oil
 engine problem
 Overload protection activated
 Short circuit protection
activated
 Defective connection or
defective cable connection
 Defective socket
www.Zipper-Maschinen.at
W A R N I N G
Behebung
 Observe the correct start procedure
 Pull recoil starter handle stronger
 Replace gasket
 Clean/exchange air filter
 Checking the fuel tank for foreign
objects
 Refuel
 Check fuel line for kinks or damage
 Unscrew spark plug, clean and dry;
then pull the recoil starter handle
several times; screw spark plug back
in again
 Screw in spark plug
 Exchange spark plug
 Plug in spark plug cap
 Clean / exchange spark plug
 Check ignition cable
 Check fuel type, use unleaded fuel,
do not use ethanol.
 Open Fuel tap
 Contact customer service
 Check engine oil level
 Contact customer service
 Contact customer service
 Clean / exchange spark plug
 Check spark plug cap
 Fill in engine oil
 Contact customer service
 Too high power consumption
 Check connected devices
 Check and repair
 Contact customer service
DISPOSAL
39