Draining The Carburettor - Zipper Maschinen ZI-STE1800IV Betriebsanleitung

20.1.4

Draining the carburettor

ZIPPER MASCHINEN GmbH
ZI-STE1800IV
4. Unscrew the spark plug (3) with the spark plug wrench
5. Gently clean the upper part of the spark plug with a fine
6. Visual check of the spark plug: if the electrodes are
7. Check the gap between the two electrodes: This should
8. The gasket ring should also be in good condition.
9. If necessary, exchange spark plug.
10. Screw in the spark plug the first few turns by hand. Be
11. Use the spark plug wrench to tighten the spark plug.
12. Reinstall the spark plug cap and the spark plug cover.
www.Zipper-Maschinen.at
(4).
wire brush. Remove the carbon deposits as well as
possible.
worn or the insulation is damaged - exchange the spark
plug.
be between 0.6 and 0.8mm.
careful not to damage the thread.
 New spark plug: tighten by 1/2 turn to compress
the washer well.
 Old spark plug: 1/4 - 1/8 turn for proper washer
compression.
 Fuel tap in position „OFF"
 Remove the side cover
 Put the drain-hose (1) into container to drain the
fuel of the carburettor
 open the drain plug (2) on the carburettor until
the fuel has drained completely.
 Tighten the drain plug (2) on the carburettor
again
 Clean the outside of the drain hose and put it
back into the machine
 Assembly the side cover again.
MAINTENANCE
N O T I C E
Fuels are toxic and must
not be released into the
environment! If necessary,
contact the local authorities
for information regarding
proper disposal.
37