Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
NOTICE:
Significantly exceeding the power capacity of the machine, which causes the overload
indicator light (red) to light up continuously, can damage the machine's motor.
NOTICE:
Exceeding the standardized power capacity of the machine for a short time is possible,
but if it is exceeded repeatedly, it reduces its lifetime. The overload indicator light (red) is only
activated temporarily here.
18.2.3 Operation of the machine to over 1500m above sea level
When is operating at high altitudes is due to the lower oxygen content in the air, the air /
fuel mixture too dense. This leads to loss of power, increased fuel consumption and the
rapid deterioration of the spark plugs and heavy start the engine.
AC Operation
Connect the devices to the AC socket. The most devices need more power for starting
than declared.
Always connect the devices in a falling chronology of their kW-consumption!
Never leave devices connected to the machine that are not in use, always disconnect
them.
DC Operation
USB port can be used to charge electrical devices (DC 5V, max. 2A) (USB standard).
Operation
18.5.1 Starting the machine
To start the machine, proceed as follows:
ZIPPER MASCHINEN GmbH
ZI-STE1800IV
1. Make sure that a grounding is established.
2. If any devices are connected to the AC or DC outlets,
3. Check the engine oil level.
4. Set the fuel tap to the "ON" position.
5. Move the fuel tank cap vent lever to the "ON" position.
6. Apply the choke lever:
www.Zipper-Maschinen.at
disconnect them.
For cold start, set the choke lever to the "START"
position.
N O T I C E
When the engine is hot or the environmental
temperature is relatively high turn the pulling
pole of the air-blocking valve to the "RUN"
position.
OPERATION
31
Werbung
Inhaltsverzeichnis
